Kathrein UFD 430 - Manual (Page 14)

Receiver operation
14
Note If the timer becomes active, “RECORD“ is indicated on the LED display for 3 sec-
onds.
During the recording period the programme selection keys are disabled.
If you press a key the following
message appears on the screen: If the programmed recording time
has ended the following message
appears:
Press the key if you want the receiver to return to normal operation, otherwise
the unit switches off after 5 minutes.
The programme number in the timer menu is set to “00“.
Attention If the timer is programmed for a recording, the unit may no longer be switched off
via the mains switch or else it must be switched on again in good time prior to the
scheduled time of recording. Both the time and the timer settings are maintained
even if the mains is disconnected.
Tip When specifying switch-on and switch-off times, add some leeway to the times so
that the entire broadcast will still be recorded even if programmes are shifted
slightly.
Daily and weekly repeated switch-on
This receiver also allows an optional daily or weekly repeated switch-on.
Daily repeated switch-on
•
Enter “00.00“ in the Date column, and also the switch-on and switch-off times.
Weekly repeated switch-on
•
Enter the relevant date of the first switch-on day in the Date column, and for the
month enter “00“.
Example:
12.00: the timer is activated for the first time on the 12th day of the month and
weekly thereafter.
Video recorder playback (VCR)
For playback from the video recorder the satellite receiver does not need to be
switched on. Standby mode is sufficient to ensure the signal path is switched
through from the VCR Scart socket to the TV Scart socket.
On playback from the video recorder the LED display shows:
-with the receiver switched on-
VCR
-in standby mode- - VCR.
On playback from the video recorder, you have the possibility of a brief switchover
to satellite reception, in order to check the start of a broadcast, for example, without
needing to switch off the video recorder.
Press the key for this.
If you press the key once again, each key-press then switches the TV picture in the
following order:
- VCR-playback
→
Sat mode
→
TV mode.