Kathrein UFD 430 - Manual (Page 8)

Connecting up and putting into operation
8
UHF connection
If your TV set does not have a Scart socket, the connection to the TV set is made
via a coaxial cable (possibly via the video recorder).
•
In this case, pull out the coaxial cable from the antenna input of the video re-
corder or TV set (if no video recorder is attached) and connect it to the satellite
receiver‘s terrestrial antenna input (view of rear panel, 3).
•
Using an additional coaxial cable, connect-up from the satellite receiver‘s TV
socket (view of rear panel, 4) to the video recorder, and from there to the TV
set.
Audio connection
If you want to hear the sound via the hi-fi system, connect the audio Cinch sockets
(view of rear panel, 6) and the hi-fi system with a Cinch cable.
Decoder connection
You can also connect-up a decoder to the receiver for Pay-TV programmes.
No further setting is necessary for decoders that require a video signal and supply
a switching signal, such as Premiere decoder and Videocrypt decoder, for exam-
ple..
Important With decoders that do not supply a switching voltage, the video signal path needs
to be set to external at the receiver (see “The video menu“ section in chapter “Pro-
gramming TV programmes“).
Also comply with the decoder‘s instructions for use!
•
Using a Scart cable connect-up the decoder to the decoder Scart socket.
Mains connection
Now connect the receiver to the mains supply using the mains cable supplied for
this purpose.
Inserting batteries into remote control handset
•
Remove the cover on the rear of the remote control handset.
•
Insert both of the batteries supplied into the remote control handset.
Make certain that the batteries are inserted with the correct polarity! Polarity is
marked at the bottom of the battery compartment.
•
Replace the cover again.
Note Exhausted batteries are special waste and should not be disposed of with house-
hold refuse. Instead, hand them in to a collection centre for used batteries!