Kathrein UFD 430 - Manual (Page 32)

Initial settings
32
Tone burst
In the “Tone burst“ menu entry the following settings of the 22 kHz signal are pos-
sible:
Switching states on setting: Switching states on setting: Switching states on setting:
22 kHz signal —> High/Low and
Tone burst —> Pos. A/B:
22 kHz signal —> Pos. A/B and
Tone burst —> Opt. A/B
22 kHz signal —> Pos. A/B and
Tone burst —> High/Low
Low
High
22 kHz
22 kHz Off
On Pos Tone burst 22 kHz Low
High
Tone burst
Tone burst 0
1
Pos. 1
Pos. 2 Tone burst
Tone burst 0
1
1
2
3
4 0
0
1
1 Off
On
Off
On
Pos. 1
Pos. 2 22 kHz
22 kHz Off
On
DiSEqC
Up to 16 inputs can be switched with the “DiSEqC“ control signal.
If the receiver is connected up to a “DiSEqC" switch-over matrix, the menu entry
must be set to “On”.
Default: OFF
Note For optimal usage it is essential to know the switching criteria and the input as-
signments of the DiSEqC switching matrices.
Thus take into account the specifications of the DiSEqC switching matrices or get
in touch with the installer of the receiving system.
DiSEqC Repeat
If the receiver is operated on a receiving system with two or more DiSEqC switch-
ing matrices connected in series (cascaded), the DiSEqC command must be re-
peated.
•
In this case set the menu entry “DiSEqC Repeat" to “1" or “2“.
Default: Off
UFO mini
With a “subscriber-controlled preprocessing system" the receiver‘s input frequency
is adjusted to a fixed input frequency. The signals are transmitted by the “sub-
scriber-controlled preprocessing system“ on this frequency. The reception pa-
rameters for the programme selection are transmitted by “DiSEqC“ command
to the receiving system and set up there.
Which setting needs to be selected "On", “UFO twin 1“ or “UFO twin 2“ is depend-
ent on the design of the “subscriber-controlled preprocessing system“.
The “UFO mini Twin“ design is a special form of the “subscriber-controlled pre-
processing system“
Note The setting is therefore to be made according to information in the “subscriber-
controlled preprocessing system“ installation guide.
Remote frequency
If you have set "On" or “UFO twin 1“ in menu entry UFO mini, make the setting in
this menu entry for the transmission frequency.
The particular transmission frequency that needs to be set in the range 0 to 2150
MHz, is given in the “subscriber-controlled preprocessing system“ installation
guide.
Note It is therefore essential to note the installation guide instructions of the “subscriber-
controlled preprocessing system“.