Konica Minolta DiMAGE Scan Dual III AF-2840 - Manual (Page 12)

G
ETTING STARTED
12
RAM-stationed programs such as anti-virus or installation-monitoring software may cause the
installer to fail. Remove or disable these programs before installing the scanner software. Reinstall
or enable the software when the installation is complete.
Do NOT connect the scanner to a computer before installing the software; if the scanner is con-
nected to the computer before the software is installed, the computer may not recognize the scan-
ner unit.
Before installing the utility software
The opening screen of the Install Shield Wizard will appear.
Click the next button to continue.
Insert the DiMAGE Scan Dual III CD-ROM into the CD-ROM
drive. The setup screen will open.
Click the “Starting up the DiMAGE Scan Dual III installer” button.
The program decompression screen will briefly appear. The Install
Shield Wizard will start automatically.
If the Install Shield Wizard does not start up automatically, exe-
cute the following procedure:
1. Initiate the run routine on the start menu.
2. Click the browse button in the run dialog box.
3. Select the CD-ROM drive from the look-in box in the browse window.
4. Open the driver folder.
5. Open the English folder.
6. Click on “Setup.exe.” It will be displayed with its location in the run dialog box:
D:\Driver\English\Setup.exe. Click OK.
In the example below, the hard disk is drive C, the CD-ROM drive is drive D, and the operating
system is Windows XP. The letters designating the drives will vary between computers.
Turn on the computer to start up the Windows operating system. Users with Windows 2000
Professional or XP should log on with the administrator privilege.
Click the yes button to accept the agreement and continue.
Read the entire agreement carefully before continuing. If you
do not agree to the terms of the license agreement, click the
no button to exit the setup program.
Installation
Installing the utility software – Windows