Konica Minolta DiMAGE Scan Dual III AF-2840 - Manual (Page 43)

Click a Job file name to select it. The Job names can be
sorted chronologically or alphabetically by clicking the name
or date radio buttons at the bottom of the dialog box.
The scan settings of the selected Job file are displayed on
the right side of the window. The Job settings vary between
the 35mm and APS film formats, see the Job file list on
page 82. Click the OK button to apply the Job settings.
When the Job file is loaded, a cropping frame will appear on
the image. The frame is proportional to the output use speci-
fied with the Job. The frame can be resized, but the propor-
tions will remain the same; the input and output values are
automatically adjusted to match the change to the cropping
frame.
Scan settings can be set for individual images in the film
holder. Once made, they will remain in effect until changed.
43
Click the scan button in the main window to start the final
scan. If the DiMAGE Scan Dual III Utility was opened in an
image-processing application, the scanned image will be
opened in that application. If the utility is used by itself, the
save as dialog box will open.
On the save-as dialog box, enter the file name, and select
the file destination and file format for the image data. When
scanning multiple images, the index thumbnail frame num-
ber will be added to the file name automatically. See page
29 for information about the file formats. When saving
JPEG files, the compression ratio can be specified. Click
the save button to complete the final scan.
Quitting the DiMAGE Scan Dual III Utility
To quit the DiMAGE Scan Dual III Utility, click the close button on the upper right corner of the
window. If the close-utility-after-scanning option is active in the preference window, the utility will
automatically shut down. Turn off the scanner with the power switch on the front of the unit (p. 19).
The procedure to cancel the scan is the same as the index scan, see the canceling the index
scan section on page (p.33).
When using a USB storage device on the same bus as the scanner, save the data on the comput-
er’s hard disk first before transferring it to the storage device. Saving the scanned data directly to
the device may corrupt the image data.