KORG Performance Synthesizer PS60 - Manual (Page 34)

31
Software Setup (Initial settings for the PS60 Editor)
Global mode Software Setup lets you specify the default settings that the PS60 Editor will use
when it starts up. This setting is saved when you use the UTILITY command Save as Default, and
will be remembered the next time you start up.
Total Recall & Data Sync Settings
Here you can specify the editor data that will be saved and loaded as part of the song data by your
DAW software. This setting lets you save only the data you need. When the PS60 Editor starts up,
the types of data that you’ve checked here will also be loaded automatically from the PS60 that’s
connected to your computer. (In other words, this data will be synchronized.)
Since a data dump requires a certain amount of time, you may wish to shorten the startup time by
using the Load Data File Automatically function instead of this function, or by using the UTILITY
command Load to load a previously-saved data file into the PS60 Editor.
Load data file automatically
When the PS60 Editor starts up, the data file that you specify here will automatically be loaded
into the editor. After this process is completed, the data you checked in Total Recall & Data Sync
Setting will be loaded via data dump.
Auto Local Control
This setting automatically sets the PS60’s Local Control setting to the appropriate state when you
start up the editor. We recommend that you normally leave this parameter on. The PS60’s Local
Control setting will be reset to its original state when you close the editor.
MIDI Settings
Here you can adjust settings for MIDI connections between the PS60 Editor and the PS60.