Linksys RVS4000 - Manual (Page 36)

Chapter  Setting Up and Configuring the Router
 4-Port Gigabit Security Router with VPN
Forward Delay Enter a number from 4 to 30. The default
is .
Force Version This is the default protocol version to use.
Select Normal (use RSTP) or Compatible (compatible with
old STP). The default is Normal.
Protocol Enable Check this box to enable RSTP on
the associated port. The default is unchecked (RSTP
disabled).
Edge Check this box to specify that the associated port
is an edge port (end station). Uncheck the box to specify
that the associated port is a link (bridge) to another STP
device. The default is checked (edge port).
Path Cost This is the RSTP path cost for the designated
ports. Enter a number from 1 to 200000000, or auto
(autogenerated path cost). The default is auto.
Status
Status > Gateway
Status > Gateway
Firmware Version Displays the Gateway’s current
firmware.
MAC Address Displays the Gateway MAC Address, as
seen by your ISP.
Current Time Displays the time, based on the time zone
you selected on the Setup tab.
Internet Connection
Connection Type Displays the type of the connection.
Interface Displays the Gateway Internet Interface.
IP Address Displays the Gateway Internet IP Address.
Subnet Mask Displays the Subnet Mask that is associated
with the IP address above.
Default Gateway Displays your ISP’s Gateway.
DNS - Displays the DNS (Domain Name System) IP
addresses currently used by this Gateway.
IP Conntrack Click this button to display the IP Conntrack
screen.
IP Conntrack
The IP Conntrack (Connection Tracking) screen displays
information about TCP/UDP connections, such as source
and destination IP address and port number pairs
(known as socket pairs), protocol types (TCP/UDP/ICMP),
connection state and timeouts. To see more information,
click Next Page or Previous Page, or select the page
from the Goto Page drop-down menu. To see the latest
information, click Refresh. Click Close to return to the
Status > Gateway screen.
Status > Gateway > IP Conntrack
Status > Local Network
Status > Local Network
Current IP address System This shows the current
system.
MAC Address This is the Router MAC Address, as seen on
your local, Ethernet network.
IP Address The Internet IP Address is displayed here.
Subnet Mask This Subnet Mask is associated with the IP
address above.
IPv Address This shows the IPv6 IP address, if
applicable.