Linksys RVS4000 - Manual (Page 55)

0
Gateway-to-Gateway VPN Tunnel
4-Port Gigabit Security Router with VPN
Appendix D
Appendix D:
Gateway-to-Gateway VPN
Tunnel
Overview
This appendix explains how to configure an IPSec VPN
tunnel between two VPN Routers by example. Two
computers are used to test the liveliness of the tunnel.
Before You Begin
The following is a list of equipment you need:
Two Windows desktop computers (each computer will
be connected to a VPN Router)
Two VPN Routers (4-Port Gigabit Security Router with
VPN, model number RVS4000, and 10/100 8-Port VPN
Router, model number RV082) that are both connected
to the Internet
Any VPN Router can be deployed, such as the Linksys
10/100 16-, 8-, or 4-Port VPN Router (model numbers
RV016, RV082, or RV042); however, this example uses the
RV082.
Configuration when the Remote Gateway
Uses a Static IP Address
This example assumes the Remote Gateway is using a
static IP address. If the Remote Gateway uses a dynamic
IP address, refer to “Configuration when the Remote
Gateway Uses a Dynamic IP.”
RVS4000
WAN: A.A.A.A
LAN: 192.168.5.1
RV082
WAN: B.B.B.B
LAN: 192.168.1.1
Gateway-to-Gateway IPSec VPN Tunnel - Remote Gateway Using
Static IP
NOTE: Each computer must have a network
adapter installed.
•
•
Configuration of the RVS4000
Follow these instructions for the first VPN Router,
designated RVS4000. The other VPN Router is designated
the RV082.
Launch the web browser for a networked computer,
designated PC 1.
Access the web-based utility of the RVS4000. (Refer to
“Chapter 5: Setting Up and Configuring the Router” for
details.)
Click the VPN tab.
Click IPSec VPN.
Enter a name in the Tunnel Name field.
For the IPSec VPN Tunnel setting, select Enable.
The WAN IP address (A.A.A.A) of the RVS4000 will be
automatically detected.
For the Local Security Group Type, select Subnet. Enter
the RVS4000’s local network settings in the IP Address
and Subnet Mask fields.
RVS4000 IPSec VPN Settings
For the Remote Security Gateway Type, select IP
address. Enter the RV082’s WAN IP address in the IP
Address field.
For the Remote Security Group Type, select Subnet.
Enter the RV082’s local network settings in the IP
Address and Subnet Mask fields.
1.
2.
3.
4.
5.
6.
7.
8.
9.