Linksys RVS4000 - Manual (Page 58)


Gateway-to-Gateway VPN Tunnel
4-Port Gigabit Security Router with VPN
Appendix D
For the VPN Tunnel setting, select Enable.
The WAN IP address (B.B.B.B) of the RV082 will be
automatically detected.
For the Local Security Group Type, select Subnet. Enter
the RV082’s local network settings in the IP Address and
Subnet Mask fields.
RV082 VPN Settings
For the Remote Security Gateway Type, select IP
address. Enter the RVS4000’s WAN IP address in the IP
Address field.
For the Remote Security Group Type, select Subnet.
Enter the RVS4000’s local network settings in the IP
Address and Subnet Mask fields.
In the IPSec Setup section, select the appropriate
encryption, authentication, and other key management
settings. (These should match the settings of the
RVS4000.)
In the Preshared Key field, enter a string for this key, for
example, 13572468.
RV082 IPSec Setup Settings
If you need more detailed settings, click Advanced
Settings. Otherwise, click Save Settings.
Configuration of PC 1 and PC 2
Verify that PC 1 and PC 2 can ping each other (refer to
Windows Help for more information). If the computers
can ping each other, then you know the VPN tunnel is
configured correctly.
6.
7.
8.
9.
10.
11.
12.
Configuration when Both Gateways Use
Dynamic IP Addresses
This example assumes both Gateways are using dynamic
IP addresses. If only the Remote Gateway uses a dynamic
IP address, refer to “Configuration when the Remote
Gateway Uses a Dynamic IP.”
RVS4000
Dynamic IP: A.A.A.A with
Domain Name: www.xyz.com
LAN: 192.168.5.1
RV082
Dynamic IP: B.B.B.B with
Domain Name: www.abc.com
LAN: 192.168.1.1
Gateway-to-Gateway IPSec VPN Tunnel - Both Gateways Using
Dynamic IP
NOTE: Each computer must have a network
adapter installed.
Configuration of the RVS4000
Follow these instructions for the first VPN Router,
designated RVS4000. The other VPN Router is designated
the RV082.
Launch the web browser for a networked computer,
designated PC 1.
Access the web-based utility of the RVS4000. (Refer to
“Chapter 5: Setting Up and Configuring the Router” for
details.)
Click the VPN tab.
Click IPSec VPN.
Enter a name in the Tunnel Name field.
For the IPSec VPN Tunnel setting, select Enable.
The WAN IP address (A.A.A.A) of the RVS4000 will be
automatically detected.
For the Local Security Group Type, select Subnet. Enter
the RVS4000’s local network settings in the IP Address
and Subnet Mask fields.
1.
2.
3.
4.
5.
6.
7.