Lexmark 1000 - Manual (Page 34)

4-6 Service Manual
4096-00X
Mid-Frame Assembly Removal
1. Remove the front cover.
2. Remove the carrier frame from the base assembly.
3. Move the printhead carrier assembly to the left.
4. Remove the maintenance station assembly.
5. Turn and remove the retainers at both ends of the large feed
roller.
6. Remove the mid-frame assembly.
Power Supply Removal
1. Remove the front cover.
2. Remove the carrier frame from the base assembly.
3. Disconnect the power supply connector from the system board.
4. Remove the screws that secure the power supply to the base
assembly and remove the power supply.
Printhead Carrier Assembly Removal
1. Remove the front cover.
2. Disconnect the printhead cable from the system board.
3. Remove the retainer spring from the right end of the carrier
guide rod.
4. Slide the carrier guide rod out the right side of the machine.
5. Remove the belt from the back of the carrier.
6. Lift the carrier out of the machine.
Small Feed Roll Assembly Removal
1. Remove the front cover.
2. Remove the carrier frame from the base assembly.
3. Remove the four small feed roller springs from the carrier frame.
4. Remove each of the small feed roll assemblies from the frame.