Lynx EPM-4 - Manual (Page 20)

CMOS Setup / Advanced Configuration
Configuration / Operation – 12 EPM-4 Reference Manual
Usually, the drive you specify here corresponds to the declaration in the Drive
Assignment Order field.
A CD-ROM drive can be inserted into the boot order by selecting “CDROM” at the
desired boot order position.
CMOS Setup / Advanced Configuration
D0000 H 64 K PAGE FUNCTION
Default: ISA bus
ISA bus
Memory accesses to the D0000h page will be sent to the ISA bus for use by PC/104
expansion modules. This setting is required when flashing the BIOS with the FBU utility.
BIOS Ext
The D0000h page is mapped to sector 1 in the flash chip, which may contain 3 rd party
Ethernet boot code or any other BIOS extension (not included). If there is a such an
extension present, it will be called by the BIOS. The BIOS extension can be programmed
into the flash chip with the FBU utility. For remote booting via Ethernet, the
recommended boot ROM is Managed PC Boot Agent from Argon Technology
Corporation.
RAM
System RAM is exposed in the D0000h page.
PLD REGISTER BASE I/O
Default: 0E0h
Specifies the location of the PLD register in I/O space. It can be moved to 1E0h in case of an
address conflict within add-in module.
F ORCE E THERNET 10-B ASE T
Default: Disabled
When enabled, this will disable the Ethernet media data rate auto-negotiation and force it to 10-
BaseT mode.
Note: Some drivers will put the Ethernet back into auto-negotiation mode.