Viewing configuration information, Items you need, Iewing configuration information – Lucent Technologies 7820-0657-001 User Manual
Page 21
DSLPipe DSU (SDSL) User’s Guide
3-1
Viewing configuration information
Before you can view the configuration information for the DSLPipe unit, you
must set up VT100 emulation to view the on-board software.
Items you need
•
You need a serial cable that can plug into an available, enabled serial port on
your computer. The other end of the cable must have a male DB-9 connector
to fit the serial port connector on the back of the DSLPipe unit. If your
computer is a Macintosh, the cable must fit the modem port’s nine-pin mini
DIN connector.
•
You also need communications software that supports VT100 emulation.
Connecting serial cable and setting up
communications software
To establish a serial connection, proceed as follows:
1
Use a serial cable to connect your computer’s serial (or modem) port to the
terminal port on the back of the DSLPipe unit.
Connecting serial cable and setting up communications software . . . . . . . . 3-1
3