Lucent Technologies 7820-0657-001 - Manual (Page 24)

Viewing configuration information
3-4 DSLPipe DSU (SDSL) User’s Guide
V35 Indicates OFF_line or ON_line
Data Bit Polarity Indicates Norm (Normal) or Rev (Reverse). The default is
Rev. This means that the transmitter inverts the data polarity
before sending data.
Sign/Magn Bit Seq Indicates Norm (Normal) or Rev (Reverse). The default is
Rev . This means that the magnitude bit is followed by the sign
bit.
Noise Margin Shows the noise margin value (in dB). If the noise margin is
less than -5dB, the SDSL line is terminated.
Data Rate Shows the current transmission rate
DSL ch Data
Encode/Decode
Shows one of the following: NRZ , NRZI , FMO , FM1 , or
Manchester . The default is NRZ. This means that signal
transmissions go from positive to negative without ever
assuming a zero value (Non-Return to Zero).
V.35 ch Data
Encode/Decode
Shows one of the following: NRZ , NRZI , FMO , FM1 , or
Manchester . The default is NRZ. This means that signal
transmissions go from positive to negative without ever
assuming a zero value (Non-Return to Zero).
DSL ch Rx CRC Shows either Enable or Disable . The default is Enable .
This means that the receiver will check for CRC over the SDSL
line.
DSL ch Tx CRC Shows either Enable or Disable . The default is Enable .
This means that the CRC is appended to the end of the frame
when data is sent over the SDSL line
.
V.35 ch Rx CRC Shows either Enable or Disable . The default is Enable .
This means that the receiver will check for CRC over the V.35
line.
Table 3-1. Fields in the DSLPipe status window (Continued)
Fields Description