Land Pride Rotary Cutters RCR1884 - Manual (Page 16)

14
Section 1: Assembly and Set-Up
RCR1884 Series Rotary Cutter 312-880M 2/03/12
Table of Contents
Single Tailwheel Assembly
Refer to Figure 1-7:
1. Slide adjustment plate (#1) onto tailwheel arm (#2).
2. Attach front end of tailwheel arm (#2) to tailwheel
deck bracket with 5/8"-11 x 3 1/4" GR5 hex head bolt
(#6), 5/8" flat washer (#9) and 5/8" locknut (#7).
NOTE: Do not tighten hardware until assembly
is complete. See “Torque Values Chart” on page
34 for correct torques.
IMPORTANT: The tailwheel arm must be located in
the rear mounting holes of the deck channel when
rear chainguards are included and front mounting
holes when rear chainguards are not included.
3. Assemble tailwheel adjusting brackets (#3 & #4) to
deck rear with four 1/2"-13 x 1 1/2" GR5 carriage
bolts (#5) and 1/2" flange locknuts (#8).
4. Install shim washer (#10) onto yoke spindle (#12)
and insert spindle into tailwheel arm (#2). Install 2nd
shim washer (#10) onto yoke spindle and secure with
roll pin (#11).
5. Assemble tailwheel adjusting plate (#1) to adjusting
brackets (#3 & #4) with two 1/2" -13 x 1 1/2" GR5 hex
head bolts (#5) and 1/2" flange locknuts (#8).
6. Refer to “Single Tail Wheel Height Adjustment” on
page 19 for adjusting instructions.
7. Tighten all locknuts to correct torque.
Single Tailwheel Assembly
Figure 1-7
24655
Tailwheel
Deck Bracket