LG LRG30357ST - Manual (Page 38)

38
STAINLESS STEEL SURFACES
Do not use a steel wool pad; it will scratch
the surface.
To clean the stainless steel surface, use warm
sudsy water or a stainless steel cleaner or
polish. Always wipe the surface in the direction
of the grain. Follow the cleaner instructions for
cleaning the stainless steel surface.
To inquire about purchasing stainless steel
appliance cleaner or polish, or to find the
location of a dealer nearest you, please call our
toll-free customer service number:
1-800-243-0000
or visit our website at:
us.lgservice.com
CA R E A N D C L E A N I N G O F T H E R A N G E
OVEN AIR VENTS
Never block the vents (air openings) of the
range. They provide the air inlet and outlet that
are necessary for the range to operate properly
with correct combustion.
Air openings are located at the rear of the
cooktop, at the top and bottom of the oven
door, and at the bottom of the range, under
the warming drawer.
CONTROL PANEL
Lock out the touch pads before
cleaning.
See the Control Lockout information in the
Special Features of Your Oven Control section
in this manual.
Clean up splatters with a damp cloth.
You may also use a glass cleaner.
Remove heavier soil with warm soapy water.
Do not use abrasives of any kind.
Unlock the touch pads after cleaning.
FRONT MANIFOLD PANEL AND KNOBS
It’s a good idea to wipe the control panel after
each use of the oven. Use a damp cloth to
clean or rinse. For cleaning, use mild soap and
water or a 50/50 solution of vinegar and water.
For rinsing, use clean water. Polish dry with a
soft cloth.
Do not use abrasive cleansers, strong liquid
cleaners, plastic scouring pads or oven cleaners
on the control panel—they will damage the
finish.
Do not try to bend knobs by pulling them up or
down or by hanging a towel or other such loads.
This can damage the gas valve shaft.
The control knobs may
be removed for easier
cleaning.
Make sure the knobs
are in the OFF
positions and pull
them straight off the
stems for cleaning.
To reinstall the knobs, make sure the knob has
the OFF position centered at the top and slide
the knob directly onto the stem.
Surface burner knob