Braun 5612 - Manual (Page 4)

4
Our products are designed to meet the
highest standards of quality, functionality and
design. We hope you enjoy your new Braun
shaver.
Warning
Your shaver is provided with a low voltage
adapter or with a charging stand. In case of
damage, you must not exchange or manipu-
late any part. Take the appliance to a Braun
Service Centre.
Technical specifications
Model 5612: Wattage via cord set 7 W,
automatic power supply 100–240 V
2 /
50–60 Hz
Model 5610: Wattage via charging stand 8 W,
automatic power supply 220–240 V
2 /
50–60 Hz
Description
1 Shaver foil
2 Cutter block
3 Release button
4 On/off switch
5 Long hair trimmer
6 Charging light
7 Special power supply cord set (model 5612)
Charging stand (model 5610)
Charging the shaver
• First charging: Using the special power
supply cord set/the charging stand, connect
the shaver to the mains with the motor
switched off. Charge it for at least 4 hours
(special cord adapter and shaver might get
warm). Once the shaver is completely
charged, shave until fully discharged. Then
recharge to full capacity again (subsequent
charges will take about 1 hour).
• The charging light shows that the shaver is
being charged. When the rechargeable
battery is fully charged, the charging light
goes off. If later on, the light comes on
again, this indicates that the shaver is being
recharged to maintain its full capacity.
• A full charge will give up to 40 minutes of
cordless shaving time depending on your
beard growth. However, the maximum
battery capacity will only be reached after
several charging/discharging cycles.
• Best environmental temperature range for
charging is 15 °C to 35 °C.
• Model 5612 only: If the rechargeable battery
is discharged, you may also shave with
the shaver connected to the mains via the
power supply cord set.
Shaving
Turn on the shaver («start»):
The pivoting cutting system automatically
adjusts to every contour of your face.
Trimmer:
When the long hair trimmer is activated, it
allows the controlled trimming of moustache
or sideburns.
Keeping your shaver in top
shape
Cleaning under running water
After each shave, turn on the shaver and clean
it under running hot water. Occasionally
use soap (natural based liquid soap without
particles and abrasive substances). Then rinse
off all foam and let the shaver run for another
moment.
Tips for the perfect shave
• We recommend that you shave before
washing, as the skin tends to be slightly
swollen after washing.
• Hold the shaver at right angles (90°) to the
skin. Stretch your skin and shave against
the direction of beard growth.
• To ensure optimum shaving performance,
we recommend to replace the shaver foil
and cutter block every 18 months, or when
the parts are worn.
English
5720453_5612/10_AMEE Seite 4 Dienstag, 28. Mai 2002 1:37 13