Braun 5612 - Manual (Page 5)

5
Dry cleaning
Instead of cleaning under running water, you
may dry clean your shaver: turn the shaver off,
remove the shaver foil (shaver head must be in
central position) and, using the brush, clean
the cutter block and the inner area of the
shaver head.
Do not clean the shaver foil with the brush.
General cleaning
About every four weeks, clean the cutter block
with Braun cleaning agents.
Put a drop of light machine oil onto the long
hair trimmer and shaver foil.
Replacing the shaving parts
The shaver foil and cutter block are precision
parts that, in time, are subject to wear.
Replace your foil frame and cutter block every
18 months and get a 25% better shave.*
(Shaver foil and cutter block: part no. F/C505,
available at your dealer or Braun Service
Centres)
* (Overall evaluation from Braun users
comparing their shave with new parts and
those used for 18 months.)
Preserving the batteries
In order to maintain the optimum capacity
of the rechargeable batteries, the shaver has
to be fully discharged (by shaving) every
6 months approximately. Then recharge the
shaver to full capacity again.
Do not expose the shaver to temperatures of
more than 50 °C for longer periods of time.
Environmental notice
This appliance is provided with nickel-
cadmium batteries. To protect the environ-
ment, do not dispose of this appliance in the
household waste at the end of its useful life.
Disposal can take place at a Braun Service
Centre or appropriate collection sites.
However, if you prefer to dispose of the
product yourself, remove the batteries as
shown on page 29.
Subject to change without notice.
This product conforms to the EMC-
Requirements as laid down by the
Council Directive 89/336/EEC and to the
Low Voltage Regulation (73/23 EEC).
5720453_5612/10_AMEE Seite 5 Dienstag, 28. Mai 2002 1:37 13