Lucent Technologies Host-Based Controller Modem AT - Manual (Page 40)

Host-Based Controller Modem Data Addendum
AT Command Set June 15, 1998
AT Fax Commands Reference (continued)
Lucent Technologies Inc. Version 1.0 40
+FPR=<n> Select Fax port rate
This command sets the DTE to DCE fax port rate.
DTE command DCE action Description or notes
•FPR • 0 Execute •IPR • 0 Select automatic rate detection
•FPR • 1 Execute •IPR • 2400 Set DTE-DCE to 2400 bit/s
•FPR • 2 Execute •IPR • 4800 Set DTE-DCE rate to 4800 bit/s
•FPR • 4 Execute •IPR • 9600 Set DTE-DCE rate to 9600 bit/s
•FPR • 8 Execute •IPR • 19 200 Set DTE-DCE rate to 19 200 bit/s
•FPR • 10 Execute •IPR • 38 400 Set DTE-DCE rate to 38 400 bit/s
•FPR • 18 Execute •IPR • 57 600 Set DTE-DCE rate to 57 600 bit/s
•FPR • ? (if all values listed above
are supported) Report (0,1,2,4,8,10,18) DCE supports 2400, 4800, 9600, 19 200,
38 400
and 57 600 bit/s
•FPR? (if •IPR • 0) Report 0 DTE-DCE rate is automatically detected
•FPR? (if •IFC • 2400) Report 1 DTE-DCE rate is 2400 bit/s
•FPR? (if •IFC • 4800) Report 2 DTE-DCE rate is 4800 bit/s
•FPR? (if •IFC • 9600) Report 4 DTE-DCE rate is 9600 bit/s
•FPR? (if •IFC • 19 200) Report 8 DTE-DCE rate is 19 200 bit/s
•FPR? (if •IFC • 38 400) Report 10 DTE-DCE rate is 38 400 bit/s
•FPR? (if •IFC • 57 600) Report 18 DTE-DCE rate is 57 600 bit/s
•FPR? (all other •IPR settings) Report 255 255 indicates invalid setting