Land Pride Skid Steer Rakes SR2690 - Manual (Page 13)

11
Section 1: Assembly & Set-up
SR2672 & SR2690 Skid Steer Powered Rakes 321-004M 4/05/12
Table of Contents
Wiring Harness Electrical Hook-Up
The wiring harness activates the hydraulic cylinder on
the rake for angling the roller 15
o
left or right.
Push Button Wiring Harness (Standard)
Refer to Figure 1-6:
The push button wiring harness is supplied from the
factory with your Powered Rake. Push and hold one of
the buttons to angle the roller in one direction and release
the button to stop rotation. Push and hold the other button
to angle the roller in the opposite direction and release the
button to stop rotation.
1. Install power cord (#1) by connecting red wire
terminal (A) to a 12 volt power source and black wire
terminal (B) to ground.
2. Mount push button control switch (#3) in a
convenient, easy to reach location.
3. Connect power cord (#1) to control switch wire (#2).
4. Install black and green cord (#4) from control switch
to bottom solenoid wire (#5) and red and white wire
(#6) to top solenoid wire (#7).
5. With hydraulics hooked-up, start Skid Steer/Tractor
and press right button to angle Powered Rake to the
right and left button to angle rake to the left.
6. If Powered Rake angles in opposite directions, then
switch plugs (#4 & #6) with solenoid wires (#5 & #7).
Deutsch 14 Pin Plug & Cable (Accessory)
Refer to Figure 1-7:
If the Skid Steer Loader is equipped with a Deutsch 14
Pin male connector, then the push button control box can
be eliminated and a 73 inch or 10 foot long Deutsch 14
pin plug & cable (#8) can be purchased to connect the
solenoid directly to the Skid Steer Loader controls.
Purchase the one that is the right length for your skid
steer from your nearest Land pride Dealer.
823-384C DEUTSCH HD30 14 PIN PLUG 73"
823-303C DEUTSCH HD30 14 PIN PLUG 10’
1. Reference solenoid on by-pass valve. Attach
connector (#4) with green wire to the bottom
solenoid connector and connector (#6) with red wire
to the top solenoid connector.
2. Install power cord (#8) by connecting the 14 pin plug
to your equipment’s mating 14 pin connector.
3. With hydraulics hooked-up, start Skid Steer/Tractor
and press right button to angle Powered Rake to the
right and left button to angle rake to the left.
4. If Powered Rake angles in opposite directions, then
switch plugs (#4 & #6) with solenoid wires (#5 & #7)
shown in Figure 1-6.
7
Standard Push Button Wiring Harness
Figure 1-6
Deutsch 14 Pin Plug & Cable
Figure 1-7
Zip Tie Hoses & Electrical Cable
Refer to Figure 1-6 or Figure 1-7:
1. Secure power cord (#10) near the solenoid valve with
zip tie (#11).
Refer to Figure 1-5 on page 10:
2. Make certain hydraulic hoses (#2A &#2B) are kept
away from all pinch points.
3. Tie hydraulic hoses (#2A & #2B) and electrical
cable (#10) together at 12" and 29" from end of quick
couplers (#3 & #4) with zip ties (#1).
33719
Push Button
Control Switch
+ Red 12V
- Black
Solenoid
Valve
30941
NOTE: Additional zip ties may be needed to
properly secure the wiring harness. Customer to
supply and locate all additional zip ties.