Lennox Hearth S1300 - Manual (Page 41)

User Guide 41
Network
Enable Data Mode
Your phone may be able to receive certain data,
depending on the system sending the information.
You cannot receive voice calls while the phone is
in data mode. To receive data, you must connect
the phone to a laptop or PC and switch the phone
from voice mode to data mode.
Note: To purchase a cable, visit
www.kyocera-wireless.com/store.
To enable data mode:
From Data Calls, select one of the following:
• Voice Only turns data mode off.
• Data, next call sets the phone to data mode
for the next incoming call or the next ten
minutes.
• Data, until off sets the phone to data mode
until the phone is off.
Enable Privacy Alert
From Privacy Alert, select Enabled to set your
phone to alert you when enhanced digital CDMA
privacy is lost or regained.
Enable Voice Privacy
From Voice Privacy, select Enhanced to use
enhanced digital CDMA privacy.
Enable Roaming Service Alert
Use this setting if you want the phone to alert you
when you roam outside of your home service
area.
From Roam/Svc Alert, select one of the
following:
• Disabled turns roaming service alert off.
• When no svc alerts you with three tones
decreasing in pitch when service is lost and
three tones increasing in pitch when service is
acquired again.
• On roam change alerts you with two
decreasing tones when roaming service is
acquired and three increasing tones when
home area service is acquired again.
• On any change alerts you with three
increasing tones if there is a change in
roaming service or three decreasing tones if
the phone loses service.
Set Roaming Restrictions
You can restrict your phone from making a call
when roaming.
From Roam Option, select Automatic (to allow
roaming) or No roaming (to disallow roaming).
82-L2609-2EN.book Page 41 Monday, July 13, 2009 2:48 PM