Lucent Technologies Ethereal - Manual (Page 83)

4.6. Capture files and file modes
While capturing, the underlying libpcap capturing engine will grab the packets from the network
card and keep the packet data in a (relatively) small kernel buffer. This data is read by Ethereal and
saved into the capture file(s) the user specified.
Different modes of operation are available when saving this packet data to the capture file(s).
Tip!
Working with large files (several 100 MB's) can be quite slow. If you plan to do a long
term capture or capturing from a high traffic network, think about using one of the
"Multiple files" options. This will spread the captured packets over several smaller
files which can be much more pleasant to work with.
Note!
Using Multiple files may cut context related information. Ethereal keeps context in-
formation of the loaded packet data, so it can report context related problems (like a
stream error) and keeps information about context related protocols (e.g. where data is
exchanged at the establishing phase and only referred to in later packets). As it keeps
this information only for the loaded file, using one of the multiple file modes may cut
these contexts. If the establishing phase is saved in one file and the things you would
like to see is in another, you might not see some of the valuable context related inform-
ation.
Tip!
Information about the folders used for the capture file(s), can be found in Appendix A,
Configuration (and other) Files and Folders .
Table 4.1. Capture file mode selected by capture options
"File" option "Use multiple
files" option
"Ring buffer
with n files" op-
tion
Mode Resulting filename(s) used
- - - Single temporary
file etherXXXXXX (where
XXXXXX is a unique number)
foo.cap - - Single named file foo.cap
foo.cap x - Multiple files,
continuous
foo_00001_20040205110102.cap
,
foo_00002_20040205110102.cap
, ...
foo.cap x x Multiple files,
ring buffer
foo_00001_20040205110102.cap
,
foo_00002_20040205110102.cap
, ...
Single temporary file A temporary file will be created and used (this is the default).
After the capturing is stopped, this file can be saved later un-
der a user specified name.
Single named file A single capture file will be used. If you want to place the
Capturing Live Network Data
69