Lexicon PCM92 - Manual (Page 13)

7
USING the PcM92
PoWeRING UP the PcM92
1. Plug in the power cord.
2. Press the Power button.
3. The Lexicon
® logo appears, and remains until the boot process is com-
plete. Next, the Preset screen appears, showing the currently loaded pre-
set.
the PReSet ScReeN
The Preset screen is the starting point for many of the instructions in this
manual, so it’s a good idea to know how to get to the Preset screen. In most
cases, pressing the Back button one or more times will take you back to the
Preset screen. If you press the Back button while viewing the Preset screen,
you’ll arrive at the Machine or System Category Selection screen. In this
case, just turn the Select knob to select a category (the current category is
marked with an asterisk), and press the Select knob to load it. You will then
be taken to the Preset screen.
The Preset screen shows the current preset and configuration. Note that the
Preset screen has two “views”: System view (for System Presets) and Machine
view (for Machine Presets). For more information about System and
Machine Presets, see page 9.
SySteM vIeW
1:Single Stereo Config
(System View)
48
Current Preset Clock Sync icon
Configuration Icon
Clock Rate
MAchINe vIeW
0:Large Hall
1:PreDelay :20ms
2:ReverbTime :2.79s
3:RvbOutFreq :6500.0Hz
48
Current Preset
Configuration Icon Soft Row Parameters
Clock Sync icon
Clock Rate