La Crosse Technology 308-807 - Manual (Page 18)

P a g e | 18
RAINFALL UNIT:
On the remote control, press the SETUP button to enter the set up menu. Use the arrows to scroll down
the third screen to Rainfall Unit of measurement. Use the RIGHT ARROW button to choose from mm or
inches. Press ENTER to confirm.
WIND UNIT:
On the remote control, press the SETUP button to enter the set up menu. Use the arrows to scroll down
the third screen to Wind Unit of measurement. Use the RIGHT ARROW button to choose from:
M/S- meters per second
Knots- 1 nautical mile per hour.
MPH- miles per hour
KM/H- kilometers per hour.
Press ENTER to confirm your choice.
SEA LEVEL PRESSURE:
On the remote control, press the SETUP button to enter the set up menu. Use the arrows to scroll down
the third screen to Sea Level Pressure. Sea Level Pressure must be programmed in hectopascal hPa.
The Pressure Unit to be display on the screen is the next item in the setup menu.
Use the RIGHT ARROW button to move to the pressure setting. Use the UP/DOWN ARROWS to change
the number value to the correct relative pressure. Press ENTER to confirm.
NOTE: Use this conversion chart to convert your local pressure to hPa.
PRESSURE UNIT:
On the remote control, press the SETUP button to enter the set up menu. Use the arrows to scroll down
the third screen to Pressure Unit. Use the RIGHT ARROW button to select from:
inHg
– inches of mercury (common in USA).
mmHg – millimeters of mercury
hPa – hectopascal
mb - milibars
Press ENTER to confirm.