La Crosse Technology 308-807 - Manual (Page 6)

P a g e | 6
INITIAL QUICK SETUP:
WIRELESS DISPLAY:

Plug in the 5.0V adapter into the adapter socket on the right side of the weather station
to power up the photo frame weather station.
IR REMOTE CONTROL:

Pull out the battery insulation sheet from the bottom of the IR remote control to activate.
PHOTOS:

Save photos (JPEG) to a USB flash drive, SD (secure digital) or MMC (multimedia card)
memory cards.

Insert memory device into the wireless display.
WIND/THERMOHYGRO SENSOR:

Select a mounting location within range of the wireless display (246ft open air).

Calibrate the direction of the wind: Use the compass on the top of the wind sensor to find
north. Hold the directional vane pointing due north and do not allow it to turn while you
insert 2-AA batteries according to the polarity indicated. The red LED indicator above the
battery cover of the anemometer will flash few times right after battery installation. At
that point, release the directional vane.
RAIN GAUGE:

Select a mounting location within range of the wireless display (131ft open air).

Lift the rain gauge cover off its base. Then carefully remove the packing tape from the
rocker assembly.

Open battery cover and insert 2-AA batteries according to the polarity indicated. Close
the battery cover. Replace and lock the rain gauge cover on the base.
SEARCH FOR SENSORS:

Go to the wireless display and enter SET UP mode (press SETUP button on remote
control).

Scroll down to WIRELESS SENSOR RECEPTION and select SEARCH NOW then
press enter.

The wireless display will search for all remote sensors.

If remote sensor readings are not displayed after 2 minutes, move the remote sensors
closer and search again.

With the display, working and reading sensors use the button on the remote control to
view weather and/or photos.
o Photo
o Weather
o Weather & Photo
o Calendar