LEICA TPS1200 - Manual (Page 112)

112 TPS1200 Check & Adjust
Adjusting the
direction of the
beam step-by-step
The following table explains the most common settings.
a) Rear
adjustment port
b) Front
adjustment port
Step Description
1. Pull the two plugs softly out from the adjustment ports on top side of the
telescope housing in face II.
)
Make sure not to break the strings of the two plugs.
2. To correct the height of the beam, insert the screwdriver supplied into the
rear adjustment port and turn it clockwise to move the dot on the target
plate obliquely upwards or anticlockwise to move it downwards.
3. To correct the beam laterally, insert the screwdriver into the front adjust-
ment port and turn it clockwise to move the dot on the target plate to the
right or anticlockwise to move it to the left.
TPS12_037
b
a