Remote escutcheon kit – LG LP091HEM-Y8 User Manual

Page 35

Advertising
background image

- 35 -

Copyright ©2008 LG Electronics. Inc. All right reserved.
Only for training and service purposes

LGE Internal Use Only

Remote Escutcheon Kit

Part No: AYRE110

Description

This kit provides an attractive replacement escutcheon (see
Figure 53). The kit allows the removal of control knobs and
graphics, which are not required when a wall thermostat is
used to control the unit.

Receiving

Upon receipt of the product, inspect the shipping carton for
signs of visible damage. Report any damage or shortage to
the carrier and note it on the delivery receipt. The unit must
be stored in its original shipping carton in a dry, secure place
prior to its installation and use.

Installation

The installation and servicing of the equipment referred to in
this booklet should be performed by qualified, experienced
technicians.

WARNING

Hazardous Voltage!
Disconnect all electric power, including remote disconnects
before servicing. Follow proper lockout/ tagout procedures to
ensure the power can not be inadvertently energized. Failure
to disconnect power before servicing could result in death or
serious injury.

Important Note:
The unit OFF switch does not disconnect all electrical power
to this unit.

1. Grasp the cabinet front as shown in Figure 54.

2. Pull the bottom of the cabinet front away from the chassis

until the retaining clips disengage as in
Figure 55.

3. Lift the cabinet front off the chassis.

4. Lifting the front edge of the escutcheon, slide the tabs at

the top of the escutcheon out of the retaining holes and
remove the escutcheon. See Figure 56.

Figure 53—Standard Escutcheon

Figure 54

Figure 55

Advertising