Disassembly instructions, 1 mechanical parts – LG LP091HEM-Y8 User Manual

Page 8

Advertising
background image

- 8 -

Copyright ©2008 LG Electronics. Inc. All right reserved.
Only for training and service purposes

LGE Internal Use Only

2.1 MECHANICAL PARTS

2.1.1 FRONT GRILLE

1. Remove the front grille. (See Figure 1)
2. To remove the front grille, pull out the bottom of

the front grille and then lift up.
Re-install the component by referring to the
removal procedure.

3. To replace the front grille, place the tabs over the

top of the unit and push the bottom of front grille
until the clips snap into place.

• This Room Air Conditioner (PTAC) discharges air

from the top of the unit through reversible, 2-position
discharge grille louvers. The unit is shipped from the
factory with the discharge grille louvers at an angle
of 40˚ off vertical. In the alternate position, the
louvers will be at an angle of 15˚ off vertical.

To adjust air direction, remove the front grille.
Remove the 4 screws that fasten the discharge grille
to the front grille.

Flip the discharge grille 180°, then reattach the
discharge grille to the front grille with 4 screws.

— Before the following disassembly, POWER SWITCH is set to OFF and disconnected the power cord.

Figure 1

40˚

15˚

Screws

2. Disassembly Instructions

Advertising