Cutting unit assembly, Danger, Table of contents cutting unit assembly – Land Pride DM36 Series User Manual

Page 13

Advertising
background image

11

Section 1 Assembly and Set-Up

5/5/08

DM36 Series Disc Mowers 327-045M

Land Pride

Table of Contents

Cutting Unit Assembly

Refer to Figure 1-5:

1.

Install the support frame (#2) to the gearbox using the
M16 bolts (#18) and lock washers (#29).

2.

Assemble the blade bar support (#4) to the support
frame (#2) using the 3/8” X 2 3/4” long bolts (#15) and
lock nuts (#20).

3.

Assemble the blade bar support (#4) to the cutting unit
and secure with 1/2” X 1 1/2” bolt (#12), lock washer
(#26) and nut (#21).

4.

Attach shield brackets (#7), (#8) and (#9). Bracket
(#7) is assembled with the longer socket head bolt.
Bracket (#8) is assembled with a 1/2” X 1 1/4” long bolt
(#16) and lock nut (#23). Bracket (#9) is assembled
with the shorter socket head bolt (#17) and lock
washer.

5.

Assemble shield (#6) to brackets with carriage bolts
(#14), washers (#24) and lock nut (#22).

6.

Assemble the guide (#5) to the cutting unit with the
1/2” X 3 1/2” long bolt (#11), flat washer (#27) and lock
nut (#23). Place the spring (#33) between the guide
(#5) and flat washer (#27).

7.

Assemble the front tarp frame (#1) and rear tarp frame
(#3) to the support frame (#2) using 3/8” X 2 1/2” bolts
(#13), lock washers, nuts (#20), pins (#32) and hair
pin cotters (#31) to secure.

8.

Position tarp over frame (#3) so the sewn end is
towards the gearbox with cut out sliding down over
(#2). Pull the other end of the tarp over the other end
of the frame and slip the eyelets over the tarp frame
ends. Fasten tarp to frame using cable ties (#34) and
(#25).

9.

Assemble bumpers (#10) to tarp frames with cotter
pins (#30).

Cutting Unit

Figure 1-5

20769

!

DANGER

Do not operate cutting unit without tarp in place!

Advertising