La Crosse Technology WS-9210U - Manual (Page 17)

17
2) Remove the protective strip from one side of the tape.
Adhere the tape to the designated area on the back of the
mounting bracket.
3) Remove the protective strip from the other side of the tape.
Position the remote temperature sensor in the desired
location, ensuring that the indoor temperature station can
receive the signal.
II. THE INDOOR TEMPERATURE STATION
The indoor temperature station can be mounted in two ways:
with the table stand or
on the wall with the use of a wall hanging screw (not included).
A. USING THE TABLE STAND
1) The indoor temperature station comes with the table stand
already mounted. If you wish to use the table-stand all that
is required is to place the indoor temperature station in an
appropriate location.
B. WALL MOUNTING
1) Remove the table stand. To do this, pull down on the stand
from the rear and rotate forward.
2) Fix a screw (not included) into the desired wall leaving
approximately 3/16 of an inch (5mm) extended from the
wall.
3) Place the indoor temperature station onto the screw using the
hanging hole on the backside. Gently pull the station down
to lock the screw into place.