La Crosse Technology WS-9210U - Manual (Page 9)

9
Note: Some locations (Arizona and parts of Indiana) do not follow
Daylight Saving Time and should select “DST 0.”
6. Press and release the “SET” button to confirm and advance to the
Time setting mode.
VI. TIME
There are two methods by which the time can be set:
A) Automatically via WWVB reception or
B) Manually.
A. WWVB (Remote Control Time)
This method requires you to do nothing except wait for the signal to be
received and to select a time zone. Reception usually takes approximately
6-10 minutes during optimal conditions. The best conditions for reception
is at night, between midnight and 6:00 AM—when there is less
atmospheric interference. To keep your time as accurate as possible, the
weather station conducts a WWVB search every night between these
hours and overrides any manually set time. The WWVB tower icon
(appearing in the TIME LCD) will flash when a signal-search is in
progress, will remain steady when the signal has been received and
nothing will be displayed in all other situations. If the WWVB time has
not been received after 10 minutes of battery installation, you may
manually set the time or leave the time function alone (once reception has
occurred the WWVB time will over ride the manual time and set
automatically).
B. MANUAL TIME SETTING
1. Press and hold the “SET” button for 3 seconds or until “12h”
flashes in the DATE LCD.
2. Press and release the “SET” button 3 more times.
3. The hour digit (default of “12” should be flashing in the TIME
LCD).
4. Press and release the “CH” button to change the hour. Press the
“CH” button once and the hour will increase by one, twice and the
hour will increase by two, etc.
5. Press and release the “SET” button to confirm the hour setting and
to advance to the minute setting mode.
6. The minute digits should be flashing. Press and release the "CH”
button to change the minutes—increasing the minutes by
increments of 1 with each press of the “CH” button.