LG RC897T - Manual (Page 16)

16
The Recorder sends commands to your connected Set-
Top Box to change the channels of it through the IR
control cable when AV1 timer recording starts.
1.
Connect the plug of the IR control cable to the IR
TRANSMITTER jack on the Recorder.
2.
Find the Set-Top Box IR Sensor. Refer to “How to
find the IR sensor on the Set-Top Box” on right.
3. On the IR control cable, attach the adhesive tape
(included) to the flat surface just below of the IR
Blaster on the IR control cable.
4.
Place the IR Blaster in front of the IR sensor on
your Set-Top Box approximately one inch away
from the remote sensor.
5.
After connecting, make the necessary setting (page
56-57).
If your Set-Top Box does not have Audio/Video Out
jacks, you cannot use the AV1 timer recording using
this connection
Important, for the Recorder to record programs
received through the Set-Top Box, the Set-Top box
must remain turned on at all times.
If your Set-Top Box has IR and RF control together,
set the control to IR on the Set-Top box to use this IR
connection
Do not connect an accessory other than the supplied
IR control cable to the IR TRANSMITTER jack.
Do not cover the transmitter.
Not all Set-Top Box devices will work with this
Recorder.
Refer to the owner’s manual of the connected Set-
Top Box as well.
Do not use RF coaxial cable to connect the
Set-Top Box
Caution Caution
Notes Notes
ANTENNA OUT
VIDEO
OUT
AUDIO OUT
Front
Rear of Recorder
Cable Box,
Satellite Box
Digital Video Recorder or
Other Set-Top Boxes
IR Control Cable
IR Blaster
Recommended Set-Top Box devices
Cable Box: Motorola, Pioneer, Scientific Atlanta,
Sony
Satellite Box: DirecTV, Echostar, Dish NetWork,
HTS, Hughes, JVC, Proscan, RCA, Sony
Digital Video Recorder: Tivo, DirecTV,
Dish NetWork, Scientific Atlanta, Motorola,
Hughes, Humax, Philips, Sony
How to find the IR sensor on the
Set-Top Box
1. Turn off the Set-Top Box.
2. Hold the Remote Control of the Set-Top Box so
that it touches the front of the device.
3. Slowly move the Remote Control across the front
of the device while pressing POWER (1 1 ) button
On and Off. You must press and release the
POWER (1
1 ) button each time you move the
Remote Control (holding down the button will not
work).
4. When the cable box turns on, you have found the
sensor. Remember the location of the sensor.
Yes
Connecting the IR control cable Connecting the IR control cable