LG RC897T - Manual (Page 66)

66
Recording
Cannot record or does b Check the remaining space on the disc.
not record successfully. b If your source is copy-protected, you cannot record it using this unit.
b Use a VR mode formatted disc for copy-once material.
Video that is ‘copy-once only’ can only be recorded using a DVD-RW disc in VR mode or
DVD-RAM disc with CPRM.
b The power may have failed during recording.
b In DVD mode, you cannot record the rated digital program, no signal, audio only, scrambled
program, etc. If the unit detects an unrecordable signal as described above during recording, the
recording will be paused. The recording will be continued when recordable signal is detected in
pause mode. If the paused recording is continued for an hour, the recording will be stopped
automatically with the message.
b If you set a DTV rating for the unit and higher rated digital programs are received, the program
cannot be recorded. Change the DTV rating level in order to record it.
Timer record does not b Clock is not set to correct time.
record successfully. b The start time of the timer recording is past.
b Two timer recordings may have overlapped, in which case only the earlier one will record
completely.
b When setting the recording channel, make sure you set the unit’s built-in tuner, not the TV’s
built-in tuner.
b If the inserted disc is damaged, the recording may not complete successfully.
b To operate Timer Record using IR control, the connected Cable Box or Satellite Box must be
turned on.
Stereo Audio Record b TV is not Stereo-compatible.
and/or Playback is b Broadcast program is not in stereo format.
not present. b The A/V Output jacks on the unit are not connected to TV A/V In jacks.
Even though the timer b There is no disc (or tape) loaded.
is set, the recorder will b A non-recordable disc (or tape) is loaded.
not record when
b Disc Protect is set to [ON] in the Disc menu (see page 58).
b There are already 99 titles (DVD-RW, DVD-R, DVD-RAM), 49 titles (DVD+RW, DVD+R(DL))
recorded on the disc.
You cannot enter a b A recording is already underway.
timer program when b The time you’re trying to set has already passed.
b There are already 16 timer programs set.
If two or more timer b The earlier program takes priority.
programs overlap b When the earlier program finishes, the later program starts.
b If two programs are set to start at exactly the same time, the program entered first takes priority.
If the disc is damaged, the recording may not complete successfully. In this case even though
the Check field shows [Rec. OK], it may not be.
If you cannot get a b Make sure the DV cable is properly connected.
picture and/or audio b Try switching off the connected equipment then switch back on.
the DV IN jack, check b Try switching the audio input.
the bullet points