Lexmark Z82 - Manual (Page 96)

Troubleshooting 9-12 9-12
Problem Cause & Solution
File setting required for I/O may not be proper.
Follow the instructions below :
1) Start your windows.
2) Select Run from Start menu.
3) Type sysedit, then click OK.
4) Select SYSTEM.INI file, and set the file as shown
below.
•
[386 Enh]
•
device = vecp.386
•
LPT1TurnAroundDelay = 50
5) Restart your Windows.
‘The scanner driver is
not installed or an
operation environment
is not set up properly.
Re-install the scanner
driver and try again’
message appears on the
screen
I/O error occurs during scanning.
Check the basic cable and the cable connection.
If you still have the same message, open the
system.ini file in the windows directory as described
above, and increase the time as much as required in
increments of 10. ‘Port is disabled.
Check if the port is
properly connected, or
power is on. Then
restart your computer’
message appears on the
screen
There is not enough memory to save the scan
image. Exit all applications currently open, if not
required, in order to save memory. ‘Memory is not enough
to save the scan image.
Exit all applications if
not required, then try
again after memory
becomes available’
message appears on the
screen