Lyngdorf Audio TDAI 2200 - Manual (Page 34)

3 4
Technical Specifi cations
Audio
Parameter Value Note
Balanced input connectors 3 pin XLR, gold-plated. Case=Gnd, Pin1=Gnd,
Pin2=Hot(+), Pin3=Cold(-)
Balanced input impedance 10kOhm AC-coupled.
Unbalanced input connectors RCA (phono) jack, gold-plated. Case=Gnd, Tip=Hot(+)
Unbalanced input impedance 10kOhm AC-coupled
DAC Out impedance 75 Ohm Gain According to volume con-
trol setting. 88 dB = 0 dB with
sensitivity normal and rel. vol-
ume 0 dB
Input sensitivity 4.4V (2.2V with high sens.) 200W/8ohms/89 dB Volume
Power Supply Variation 26dB 65V to 3.3V dep. On Volume
Output connectors 4 insulated binding posts, gold-
plated.
Will accept bare wire ends of up
to 5 mm diameter.
Output power, 8ohms 2*200W 1KHz, 0.1% THD+N
Output power, 4ohms 2*375W 1KHz, 0.1% THD+N
Nominal load impedance 4 Ohms-8 Ohms It is safe to operate the amplifi er
with no load.
Frequency response 0.3Hz-33KHz -3dB points, 8ohms load.
Frequency response -0dB/+0.2dB 20Hz-20KHz, 8ohms load
Frequency response -0.2dB/+0dB 20Hz-20KHz, 4ohms load
Output impedance 0.035 Ohms 20Hz-1KHz
Output impedance 0.4 Ohms 20KHz
THD+N, 1W/8ohms 0.015% A-wgt.
THD+N, 1W/4ohms 0.02% A-wgt.
THD+N, 100W/8ohms 0.008% A-wgt.
THD+N, 180W/8ohms 0.01% A-wgt.
THD+N, 375W/4ohms 0.07% A-wgt.
S/N ratio 107dB A-wgt. Ref. 200W/8ohms.
Dynamic range 133 dB A-wgt. Ref. 200W/8ohms.
Channel separation 90dB 1KHz, 200W/8ohms.
Peak output current ±40A
Output common mode voltage Max 33V DC Ref. Ground. The amplifi er can
not be used in bridged mono
mode.
Output DC voltage ±5 mV
All audio measurements, except frequency response, are measured with a 20KHz low-pass fi lter in ac-
cordance with AES-17.