Lyngdorf Audio TDAI 2200 - Manual (Page 7)

7
Front Panel
I TDAI 2200 Digital Amplifier
Controls
The buttons/controls on the front panel of the TDAI 2200 can all be operated either with direct presses
or by operating the corresponding keys on the supplied remote control. All the keys on the front panel
[except the Mains switch (1)] are duplicated on the remote control as well.
1. Mains switch
Powers the TDAI 2200 on/off.
Stand-by mode is selected by pressing the mute button (2) for 3 seconds or with the stand-by button on
the remote control.
2. Mute
Toggles Mute mode on/off.
Pressing the Mute button for 3 seconds will set the TDAI 2200 in stand-by mode.
3. Analog Input selector
Changes to Analog input, or if already selected, cycles to the next Analog input.
Switches the TDAI 2200 on from stand-by mode.
4. Digital Input selector
Changes to Digital input, or if already selected, cycles to the next Digital input.
Switches the TDAI 2200 on from stand-by mode.
5. Display
Display with all information on menu system, status, active input selection and volume control.
6. Volume wheel
Optical encoded volume control wheel
7. Navigation keys
In normal operation mode the Up/Down toggles between bypass and the available Focus and Global
fi lters whereas the Left/Right toggles between neutral and the available voicings.
In menu mode used for navigation in the menu system: Up/Down, Left/Right & Enter.
8. Menu button
Toggles Menu mode on/off