Linksys E2100L - Manual (Page 32)

29 Advanced Wireless-N Router
Linksys E2100L Chapter 3: Advanced Configuration
7 . Click Save Settings to apply your changes, or click
Cancel Changes to clear your changes . Click Close to
exit the screen and return to the FTP Server screen .
Edit an FTP Folder
After you clicked Edit, the FTP Folder screen appears .
FTP Folder
Make the appropriate changes to the following options:
Display Name The current Display Name is shown . If you
want to change the name, enter a new name .
Partition The name of the partition is displayed .
Share entire Partition If the FTP folder should include
the entire partition, select this option . If you do not want
to share the entire partition, then select the folder you do
want to share .
New Folder If you want to create a new folder, enter its
name and then click Create .
Current Folder The selected folder is displayed .
Folder The available folders are listed by Folder name .
• Enter into Folder To display sub-folders, click this
option .
• Select To specify a folder, click Select .
• Return to Upper Folder To return to the previous
folder, click this option .
Access Specify which user groups have read-and-write or
read-only access to the FTP folders . (To create user groups,
refer to Create or Edit a Group Account, page 30 .)
• Available Groups To allow a group access to the FTP
folder, select it, and then click the >> button .
• Groups with Access To block a group from accessing
the FTP folder, select it, and then click the << button .
Click Save Settings to apply your changes, or click Cancel
Changes to clear your changes . Click Close to exit the
screen and return to the FTP Server screen .
Storage > Administration
The Administration screen allows you to manage the user
groups and individual users who can access the shared
folders .
Storage > Administration
Information
Server Name Enter the server name for the Router; it
will be used for the disk and media server features . Use
only alphanumeric characters (letters A to Z and numbers
0 to 9) in the server name . The default server name of the
Router is Ciscoxxxxx (xxxxx are the last five digits of the
Router’s serial number) .
NOTE: If you used the setup software for
installation, then the name of your wireless
network (up to 15 characters) is the server
name of the Router .
Workgroup Name Enter the workgroup name for the
Router; it should match the workgroup name of the
computers on your local network . The Router’s default is
workgroup .
Server LAN IP Address The local IP address of the Router
is displayed .
Server Internet IP Address The Internet IP address of
the Router is displayed .