LightSpeed Technologies CAT 860 - Manual (Page 10)

18 19
1. Overview
2. Setup & Use
3. Optional Accessories
4. T
roubleshooting
5. W
arranty
, Safety
& Specifications
1. Overview
2. Setup & Use
3. Optional Accessories
4. T
roubleshooting
5. W
arranty
, Safety
& Specifications
1. Screw the bracket to a place high
on the wall or in the middle of the
solid ceiling. Mount the bracket
horizontally as shown above.
2. Uncoil the Cat 5 sensor cable.
Connect one end of the cable to
the ISR. Route the wire back to
the CAT 860 amplifier, securing
it along with way using surface
raceway where possible.
3. Slide the ISR onto the bracket until
it “clicks” into place.
2. IR SENSOR/RECEIVER (ISR) INSTALLATION
CONT’D
Wall/Solid Ceiling Mount
a. Guide the mounting rails onto
the bracket, oriented as
pictured.
b. Once secure, the ISR locks
into place.
c. To remove the ISR, slide a ruler
or screwdriver behind the ISR to
press the release bar down and
slide the ISR off the bracket
4. Connect the other end of the Cat
5 sensor cable into the SENSOR
INPUT jack on the CAT 860
amplifier.
2. IR SENSOR/RECEIVER (ISR) INSTALLATION
CONT’D
Once you find a suitable location for the ISR, follow these instructions to mount
it. There are different instructions for mounting depending on if the ISR will be
mounted to a suspended ceiling grid or secured to a wall / solid vertical surface.
1. Attach the bracket to the ceiling
tile grid (t-bar).
a. Slide the tabs onto the outsides
of the t-bar, starting with one
corner.
b. Attach the second tab around
the other side of the t-bar.
c. Repeat with the other side of
the bracket so it is connected at
all four points.
2. Slide the ISR onto the bracket until
it “clicks” into place.
a. Guide the mounting rails onto
the bracket, oriented as
pictured.
b. Once secure, the ISR locks into
place.
c. To remove the ISR, press the
release bar down and slide the
ISR off the bracket.
3. Uncoil the Cat 5 sensor cable.
Connect one end of the cable to
the ISR. Secure wire overhead and
route it back to the system.
4. Connect the other end of the Cat
5 sensor cable into the SENSOR
INPUT jack on the CAT 860
amplifier.
Suspended Ceiling Mount
clip connects to t-bar on ceiling
Release Bar