LightSpeed Technologies CAT 860 - Manual (Page 11)

20 21
1. Overview
2. Setup & Use
3. Optional Accessories
4. T
roubleshooting
5. W
arranty
, Safety
& Specifications
1. Overview
2. Setup & Use
3. Optional Accessories
4. T
roubleshooting
5. W
arranty
, Safety
& Specifications
5B. ISR CONNECTION
5A. CONNECT THE POWER SUPPLY
1. Ensure the power is still switched
off.
2. Check the connection from the ISR
to the CAT 860. Ensure the sensor
cable is securely attached and
locked into place.
1. Ensure the power button is
depressed in the OFF position.
2. Connect the CD end of the power
supply to the black power jack
labeled DC POWER.
3. Connect the black AC power cable
from the power supply to a wall
outlet.
RS-232 IN
Front Panel RS-232
Control Select 1 2 + + - -
CAT 860 Amplifier
DC Power Source Cable
ISR Sensor/Receiver
CAT 860 Amplifier
The CAT 860 systems include a bracket for optional wall-mounting.
4. SPEAKER INSTALLATION
3. INSTALLATION OF AMPLIFIER WALL-
MOUNT BRACKET
1. Locate the speaker installation
instructions packed with your
speaker(s).
2. Follow instructions and mount
speaker(s).
3. Return to this manual to complete
the set up of your system.
A. Determine the location:
a. It should be located near a
power outlet.
b. Height should allow for access to
front control panel, but also be
in compliance with building and
ADA regulations.
B. Screw the bracket to the wall at
the two screw hole points with
the included hardware. Attach
to a stud when possible; use the
drywall mollies when studs are not
available.
C. Slide the CAT 860 onto the bracket
using the channel on the bottom
of the amplifier.
D. Secure the CAT 860 to the bracket
by tightening the screw on the
bottom.
E. Now that the CAT 860 is secure,
it can be slowly pulled out and
pivoted for better access to the
back panel. Push the CAT 860 back
in, to lock into place.
F. The power supply can be set
on the back of the bracket and
secured with ties if desired.