LightSpeed Technologies CAT 860 - Manual (Page 39)

76 77
1. Overview
2. Setup & Use
3. Optional Accessories
2. Setup & Use
3. Optional Accessories
4. T
roubleshooting
5. W
arranty
, Safety
& Specifications
1. Overview
4. T
roubleshooting
5. W
arranty
, Safety
& Specifications
NOTE: If the system was purchased
without a REDMIKE or REDMIKE VC,
the REDMIKE Share will utilize the
charger jacks on the back of the CAT
860.
1. Ensure that the REDMIKE Share is
turned OFF.
2. Make sure the cradle charger
is plugged into a wall outlet.
Connect one end of the charging
cable into the jack labeled
CHARGER on the bottom of the
REDMIKE Share.
3. Plug the other end into the
charging jack on the rear of the
cradle charger.
4. The LED on the microphone will
glow RED to indicate charging.
5. Leave the REDMIKE Share
plugged in overnight (8-10 hours)
to obtain a full charge.
REDMIKE Share: Charging
RS-232 IN
Front Panel RS-232
Control Select 1 2 + + - -
1
2
3
5
1. POWER SWITCH
2. POWER/CHARGE INDICATOR:
this light glows blue when turned
on and turns off to indicate low
battery level. When charging, the
light glows red.
3. AUDIO INPUT: plug a laptop,
MP3 player or other audio device
into this jack to wirelessly transmit
the audio signal to be played
through the system.
4. CHANNEL SELECT SWITCH
(CH A/B): Located in the battery
compartment, this switch is set to
Channel B at the factory.
5. CHARGER INPUT: Plug the
charging cable from the REDMIKE
cradle charger or into this jack.
REDMIKE Share: Controls and Connections
4