Assembly instructions – Land Pride Z52 User Manual
Page 3
3
06/28/07
Manual No. 356-537M
Assembly Instructions
Land Pride
■
1.
Install double pulley (13) with the bolt (11) and existing
flat washer (12) Torque bolt 65 - 75 lbs.
2.
Reinstall blade drive belt on lower grove of pulley (13).
3.
Assemble bracket (4) where the chute bracket was
assembled using the existing hardware (2) and (3).
4.
Install discharge adapter plate (21) to mower deck
with two 3/8" x 3/4" hex head cap screws and flange
lock nuts (22) as shown. Torque nuts to 31 ft. lbs.
5.
Assemble blower pivot (5) with carriage bolt (6) and
existing hardware (7), (8), (9) and (10).
6.
Assemble lower blower cover (19) to blower (1) with
two 3/8" x 1" hex head cap screws (20) four 3/8"
flatwashers (3) and two 3/8 hex nuts (2) as shown.
Torque nuts to 31 ft. lbs.
7.
Install blower (1) on blower pivot (5) and swing blower
around and secure to bracket with pin (14) and hair pin
cotter (15).
19908
Route Belt to
Top Pulley
Refer to Figure 3
8.
Install blower belt (16) to double pulley and route it
as shown. (Belt must be on top pulley)
9.
Assemble pulley cover (17) using existing knobs
Blower
Drive Belt (16)
20855
Figure 3 Blower Belt