Lynx Professional Grills 27" Free Standing Grill L27PSR-2 - Manual (Page 29)

29
note:
lynx built-in grills are intended
either for installation in a
built-in enclosure constructed
of non-combustible materials
or for an installation in a built
in enclosure constructed of
combustible material when
installed with a lynx insulating
jacket (liJ).
for non-combustible applica-
tions, the grill drops into the
opening shown in the cutout
detail drawing (see indeX: “gas
Requirements”) and hangs from
its counter-top trim. a deck is
not required to support it from
the bottom.
when using the insulated
jacket in a combustible
enclosure, the jacket must be
supported from the bottom by
a ledge on each side or a full
deck beneath the jacket.
(See INDEX: “Gas Requirements”)
pay special attention to the
provisions shown for gas line
hook-up.
the enclosure should have
ventilation holes to prevent
gas build-up in the event of
a leak. the deck ledges and
counter should be flat and
level. (refer to ansi Z21.58
standard for outdoor cooking
gas appliances, section 1.7
enclosures for self contained
lp-gas supply systems)
This grill requires that a 120
volt, 60 hertz, 15 amp gfi
certified outlet be installed by
a qualified electrician.
clearance to com-
bustIble materIals:
minimum clearance from the
sides and back of the grill to
adjacent combustible con-
struction below the top of
unit are 12” from the sides
and back.
dégagement minimal entre
les parois latérales et l’arrière
de l’appariel et la construc-
tion combustible au-dessous
du panneau supérieur de
l’appareil (30 cm à partir des
parois latérales et 30 cm à
partir de l’arrière).
minimum clearance from
sides and back of unit to
adjacent combustible con-
struction extending above the
unit is 18” from the sides and
back.
dégagement horizontal
minimal entre les parois
latérales et l’arrière de
l’appariel et la construction
verticale combustible au-
rear Hood clearance:
A 3 inch clearance is required behind the grill to allow the front
hood to open.
the grill exhausts combustion products and cooking greases to
the back. Never locate the grill where this exhaust will be difficult
to clean.
(3” min)
dessus de l’appareil (45.7 cm
à partir des parois latérales et
45.7 cm à partir de l’arrière).
do not use this appliance
under overhead combustible
surfaces.
ne pas utiliser cet appareil
sous une surface combus-
tible.
a minimum of 6” of clearance
is needed on the left side of
the grill above the counter
top for the motor and skewer.
if the grill is to be placed into
a combustible enclosure, an
approved insulated jacket
is necessary and is available
only from your lynx dealer.
lynx insulated jackets have
been designed and tested
specifically for your Grill.