Lenoxx Electronics PH568 - Manual (Page 18)

IB-PH568-WM-E-040506
•
To erase ALL call records, make sure the phone
is not in use, press the DELETE button and
hold for 3 seconds, the display will show “DELETE
ALL?”, press the DELETE button again.
CHECK
•
You picked up the phone before the second ring,
or your phone received unclear call information.
Static can cause this message.
• If this condition persists, contact your local
telephone company to ensure that there is no
problem with your phone line.
• Handset clip was not installed properly for wall
use. See page 14 for details.
16
TROUBLE SHOOTING (continued)
appears in the display..
Cannot erase all records in memory.
Caller ID displays words like
, or
or .
•
Your language is set for French or Spanish,
reset the language to English (see page 9).
Memory Dialing does not work.
Handset falls out of phone base when
wall mounted.
Caller’s information is not registered
to the Caller ID memory.
Message Waiting does not work.
PROBLEMS
•
Check if shows in the display. Since the
REDIAL/PAUSE button has combined function
(pause function), the phone may have been
paused. Just press the HOOK switch.
REDIAL does not work.
Feedback or squealing when
using SPEAKERPHONE. • Volume is too high. Reduce the SPEAKER-
PHONE VOLUME control setting.
•
Check if you have stored the numbers correctly
by pressing that memory location button(s).
•
The caller may have an unlisted or blocked
number to prevent Caller ID identification, or it
may be an overseas call or you may have noise
on the line during that call.
• Check with your telephone company if this
service is available and if you have subscribed
for it.
Static noise on line or cannot hear
calling party or calling party cannot
hear you.
•
Make sure the handset cords connected
properly. Or, replace the COILED HANDSET
CORD. Any phone store has these cords in
different lengths. After some time the cord may
have become overstretched or damaged.
IB-PH568-WM-E-040506(RTT).pmd 7/4/2006, 4:28 PM 18