Lenoxx Electronics PH568 - Manual (Page 9)

IB-PH568-WM-E-040506
3. Replace the battery door and snap it shut (FIG. 3).
INSTALLING THE BATTERIES (If no AC adaptor is used)
Before you connect the phone cords, you must install the batteries by following the steps below:
1. Insert a flat blade screwdriver or coin like a quarter into the slot and pry out (lift) the
battery door (FIG. 1).
2. Insert 4 size “AA” alkaline batteries as shown inside the battery compartment, the “–” side
of the battery touches the spring (FIG. 2).
CAUTION
Replace the batteries when the low battery icon
LOW
flashes in the display. Because when
the batteries are dead and the AC adaptor is not connected, the phone will not work
properly and your data and settings could be erased.
FIG. 2 FIG. 1 FIG. 3
SETTINGS
CONNECTING THE HANDSET AND THE AC ADAPTOR
1. To use the two line and conference call functions, you need to use the supplied AC
adaptor (9V AC output). Insert the adaptor’s small connector plug into the AC 9V jack on
the rear of the phone, and plug the adaptor into any wall outlet that is not shut off by a
light switch.
2. Connect the handset coiled cord to the handset and the handset jack on the left side of
the phone.
CAUTION:
• To prevent electric shock, do not use the AC Adaptor with an extension cord or outlet,
unless it can be fully inserted without exposing any part of the blades.
• Only use the supplied AC adaptor.
• During a power failure, the unit will work as a standard telephone on the line 1, but the
caller ID, speakerphone, line indicator, hold, LCD display features will not work, unless the
batteries are installed. Line 2 is not available.
• If you did not install the batteries, the low battery icon
LOW will flash in the display, to
prevent the data and settings missing during the power failure, we recommend you also
install the batteries when you use the AC adaptor.
7
wall outlet
(AC 120V, 60Hz)
IB-PH568-WM-E-040506(RTT).pmd 7/4/2006, 4:28 PM 9