LEICA GPS1200 - Manual (Page 46)

46 GPS1200+ Operation
Attach a clip-on-
housing step-by-
step The clip-on-housing for devices fits on either of the small sides of the receiver.
Detach a clip-on-
housing step-by-
step
Step Description
1. Place the clip-on-housing into position such that the guide rails for the clip-
on-housing on the receiver and the guide rails on the clip-on-housing are
aligned.
2. Ensure that the connector on the clip-on-housing fits to port P1 or port P3
on the receiver front panel.
3. Slide the clip-on-housing towards the receiver front panel until the
connector is completely plugged into port P1 or port P3.
4. On the top side of the clip-on-housing, turn the screw clockwise, as shown
by the symbols on the screw, to lock the clip-on-housing to the receiver.
Step Description
1. On the top side of the clip-on-housing, turn the screw anticlockwise, as
shown by the symbols on the screw, to unlock the clip-on-housing from the
receiver.
2. Slide the clip-on-housing away from the receiver front panel until the
connector is completely unplugged from port P1 or port P3.