Link electronic Wireless 802.11g AP Router - Manual (Page 30)

User’s Guide 29
4.10. Routing Table
On the Routing Table screen, you can set the routing mode and settings of the Router. Gateway mode
is recommended for most users.
Operating Mode
The default setting is Gateway.
Choose the correct working mode. Keep the default setting, Gateway, if the Router is
hosting your network's connection to the Internet (Gateway mode is recommended for
most users). Select Router if the Router exists on a network with other routers.
Dynamic Routing
(RIP)
Note: This feature is not available in Gateway mode.
The default setting is Disable.
Dynamic Routing enables the Router to automatically adjust to physical changes in the
network's layout and exchange routing tables with other routers. The Router determines
the network packets' route based on the fewest number of hops between the source and
destination.
To enable the Dynamic Routing feature, select Enable. To disable the Dynamic Routing
feature for all data transmissions, keep the default setting, Disable.
Static
Routing, Destination
IP Address, Subnet
Mask, Gateway, and
1. To set up a static route between the Router and another network, select a number from
the Static Routing drop-down list. (A static route is a pre-determined pathway that
network information must travel to reach a specific host or network.)