Link electronic Wireless 802.11g AP Router - Manual (Page 6)

User’s Guide 5
3. Hardware Installation
Front Panel
The front panel provides LED’s for device status. Refer to the following table for the meaning of each
feature.
LED STATUS Description
Off
No power
Red On
1. Power on 2. Reset to default 3. Firmware upgrade (first 1
minute)
PWR/STAT
Red Blink 1. System up 2. Power on 3. Firmware upgrade
Off
no Ethernet link detected
Green On 10/100Mbps Fast Ethernet link detected. No activity.
LAN
Green
Blink
Indicates data traffic on the 10/100 Mbps LAN
WAN
Orange
Blink
Indicates data traffic on the 10/100 Mbps LAN
G
Yellow
Blink Indicates the device is linking or active data through wireless
links
Rear Panel
The rear panel features 4 LAN ports, 1 WAN port and Reset button. Refer to the following table for the
meaning of each feature.
Power (DC 5v)
Used to connect to the power outlet. Only use the power
adapter provided with the device. Use of an unauthorized
power adapter may cause damage to your device and
violate your warranty.
Reset
Press the Reset Button for approximately ten seconds, all
configurations will set to factory default settings.
LAN
The RJ -45 Ethernet ports used to connect your PC, hub,
switch or Ethernet network.
WAN
The RJ-45 Ethernet port labeled WAN is used to connect
your AP Router to your xDSL or Cable modem.
AP Router Default Settings
The default settings are shown following.
User
Password admin
AP Router IP
Address
192.168.1.1
AP Router Subnet
Mask
255.255.255.0
RF ESSID wlan-g
11g RF Channel 6
Mode 11b+11g
Encryption Disabled
DHCP client Enabled