Lancom Systems 7111 VPN - Manual (Page 21)

LANCOM 7111 VPN – LANCOM 8011 VPN
̈ Chapter 2: Installation
21
EN
VPN
»
VPN connection status
Security
¿
Status of the Firewall. Shows the state of security settings and blocked attacks
on the secured network.
Flashing Power LED but no connection?
There's no need to worry if the Power LED blinks red and you can no
longer connect to the WAN. This simply indicates that a preset time or
connect-charge limit has been reached. There are three methods
available for unlocking:
̈ Reset connect charge protection.
̈
Increase the limit that has been reached.
̈ Completely deactivate the lock that has been triggered (set limit
to '0').
If a time or connect charge limit has been reached, you will be notified in LANmonitor. To
reset the connect charge protection, select Reset Charge and Time Limits in the context
menu (right mouse click). You can configure the connect charge settings in LANconfig under
Management
̈ Costs (you will only be able to access this configuration if 'Complete con-
figuration display' is selected under View
̈
Options…).
You will find the connect charge protection reset in WEBconfig and all parameters under
Expert Configuration
̈
Setup
̈
Charges-module.
Signal for reached time
or connect-charge
limit
Power Power
LANCOM
Systems
off No VPN channel established
green blinking Connection established
green flashing First connection
green inverse flashing Further connections
green constantly on VPN channel is established
green constantly on Security settings are okay. Rules for filtering packets are
established
red/
green blinking Insecure configuration
red flickering Security alarm: filtering packets with Firewall rules