Lancom Systems 7111 VPN - Manual (Page 36)

LANCOM 7111 VPN – LANCOM 8011 VPN
̈ Chapter 3: Basic configuration
36
EN
ቤ In the following 'Security settings' window, specify a password for config-
uration access. Note that the password is case-sensitive and ensure that
it is sufficiently long (at least 6 characters).
You may specify whether the device may only be configured from the local
network or whether remote configuration via the WAN (i.e. a remote net-
work) is also permissible.
Please note that enabling this will also permit remote configuration
via the Internet. You should always make sure that the configuration
access is suitably protected, e.g. with a password.
Remote configuration via a direct ISDN connection is available independ-
ently of the WAN remote configuration: in this case, the configuration PC
establishes a direct dial-up ISDN connection to the LANCOM router, for
example using Windows Dial-Up Networking. ISDN remote configuration
can be enabled by specifying an MSN/terminal device selection digit for
it. In this case, the LANCOM router will accept calls on that MSN/terminal
device selection digit and can be remotely configured via the ISDN con-
nection.
Confirm your selection with Apply.
ብ In the next window, select your DSL provider from the list that is displayed.
Confirm your choice with Apply.
If you select 'My provider is not listed here,' you must enter the transfer
protocol used by your DSL provider manually in the next window. Confirm
your choice with Apply.
Entering the password in the web browser
When you are prompted for a user name and password
by your web browser when accessing the device in the
future, enter your personal values to the corresponding
fields. Please note that the password is case-sensitive.
If you are using the common configuration account,
enter the corresponding password only. Leave the user
name field blank.
Entering the configuration password