See figure b.4), Operation – Lincoln Electric POWER MIG SVM170-A User Manual
Page 19
B-7
OPERATION
B-7
POWER MIG 255C
5. Loosen the socket head cap screw that holds the
connector bar against the gun bushing.
Important: Do not attempt to completely remove
the socket head cap screw.
6. Remove the outer wire guide, and push the gun
bushing out of the wire drive. Because of the pre-
cision fit, light tapping may be required to remove
the gun bushing.
7. Disconnect the shielding gas hose from the gun
bushing, if required.
8. Connect the shielding gas hose to the new gun
bushing, if required.
9. Rotate the gun bushing until the thumb screw hole
aligns with the thumb screw hole in the feed plate.
Slide the gun receiver bushing into the wire drive
and verify the thumb screw holes are aligned.
10. Tighten the socket head cap screw.
11. Insert the welding gun into the gun bushing and
tighten the thumb screw.
BUJE DEL RECEPTOR DEL ARMA
GUN RECEIVER BUSHING
DOUILLE DE RCEPTEUR DE PISTOLET
LOOSEN TIGHTEN
AFLOJE APRIETAN
DESSERREZ-VOUS SERRENT
TORNILLO DE PULGAR
THUMB SCREW
VIS DE POUCE
OUTER WIRE GUIDE
GUIDE DE CBLAGE EXTERNE
GUŒA DE ALAMBRE EXTERNA
SOCKET HEAD
CAP SCREW
VIS PRINCIPALE DE
LA DOUILLE CAP
TORNILLO DE CASQUILLO
DE LA CABEZA DE ZCALO
CONNECTOR BLOCK
BORNIER
BLOQUE DE CONECTADOR
FIGURE B.4