Lionel Trains 71-8340-250 - Manual (Page 19)

TrainMaster Command Control operations
CAB-1 Remote Controller numeric keypad commands
W hen you press the AUX1 button on your CAB-1 Remote Controller, you turn the numeric
keypad into ten command buttons. These commands are specific to
your locomotive set, and an overlay is included to help you learn these
functions. After you press the AUX1 button, you will be able to press any
numbered button until you address a different Command Control equipped
product. The corresponding RailSounds sound system effects
are in bold italic type.
Stops and resets the locomotive set. Resets the locomotive set’s
direction to forward. Resets the RailSounds sound system to automatic RPM operation.
Horn blows. RPM sounds return to automatic.
Raises the volume of the RailSounds sound system. Sound volume increases.
Activates CrewTalk communication, unintelligible radio dialogue. CrewTalk
communication.
Increases the RailSounds sound system RPM level. Starts the RailSounds sound system.
RPM level increases. Start-up sequence commences.
Lowers the volume of the RailSounds sound system. Sound volume decreases.
Activates the shutdown sequence. Like prototypical locomotive sets, the RPM level must be
at idle for shutdown to occur. Press 6 repeatedly to lower the RPM level until the RPM
sounds reach idle. Press 5 to initiate the shutdown sequence and listen for the CrewTalk
communication. Keep in mind that the horn, bell, and RPM sounds are inactive until you
restart the RailSounds sound system by pressing 3. CrewTalk communication.
Diesel shutdown sequence.
Lowers the RailSounds sound system RPM level. RPM level decreases.
Activates a TowerCom announcement, which includes a call-out specific to your locomotive
set. Pressing AUX1, 7 triggers a “hold for clearance” message. Press 7 again, and a “clear
for departure” message plays. There is a four-second delay in this function. TowerCom
announcement.
Turns off the smoke units and the radiator fans. Air release sound.
Turns on the radiator fans. Also, turns on the smoke units if the smoke unit switches are in
the ON position. Be sure to add smoke fluid before turning on the smoke units to prevent
damage to your locomotives. Air release sound.
You may use the CAB-1 Remote Controller to turn on the smoke unit only if the
locomotive set’s smoke unit switches are in the ON position. The smoke unit switch
does not control the radiator fans.
19
Note!
➠
➠
➠
➠
AUX1